|
|
|
 | TAPPING & DRILLING DEVICE: | | | | MAIN SPINDLE & TOOL RACK: | | The main spindle is made by special steel which has been treated through heat treatment and ground precisely. This machine is equipped with 5 sets of tools and high precision can be achieved through the equipped micrometer. The sliding plate is made by high quality cast iron which is also treated through heat treatment and ground precisely. | | TWO SHAFT DEVICE: | | This adopts magnetic clutch to drive the tapping shaft, and tapping can be achieved by use of the revolution difference between main spindle and tapping shaft in the same direction. Reaming, deep hole drilling and inside or outside tapping can be completed in a cycle by shaking to exchange both of the shafts. | | CAM & CAM SHAFT: | | Plate cam is for a radial cutting, bell cam is for axial cutting. At the central journal, the cam shaft is divided into two portion. Convenient and save much time to exchange cams. Also, it can be changed into by manual rotating when necessary. |
| |
|
|
| Specifications: | | | | Item | G-1525A | G-2025A | UNIT | | Spindle speed | 2100-7000 | 2100-7000 | rpm | | Cam shaft speed | 1.3-25 | 1.3-25 | rpm | | OD tool rest Nos. | 5 | 5 | pcs | | ID tool rest Nos. | 2 | 2 | pcs | | Drill chuck |  15# | 15# | pcs | | Collet chuck |  15# | 20# | pcs | | Tool blank Nos. | 5 | 5 | pcs | | Tool blank size | 8 * 8 | 8 * 8 | mm | | Max. processing dia. | Ø15 | Ø20 | mm | | Max. processing length-Slide stravel | 35 | 35 | mm | | Max. drilling dia. | 10 | 15 | mm | | Max. drilling depth | 40 | 40 | mm | | Max. tapping dia. | M10 * P1.25mm | M10 * P1.25mm | Cu | | Max. turned taper-Slide taper | 10° - 15° | 5 | mm | | Spindle speed steps | 5 | 5 | steps | | Cam shaft speed steps | 15 | 15 | steps | | Spindle motor | 2 HP/1.5 KW | 2 HP/1.5 KW | HP | | Cam shaft motor | None | None | HP | | Coolant pump motor | 1 / 4 | 1 / 4 | HP | | Coolant tank | L  :65  :80 | L :65 :80 | L | | Spindle center height | 1055 - 1080 | 1055 -1080 | mm | | Weight | 850 | 850 | KG | | Lathe size | 1500*750*1450 | 1500*750*1450 | mm |
|
|
| Standard Accessories: | | | | Item | UNIT | | Dies holder ¡í20 & ¡í25 | SET | | Cam blank | SET | | Tool box & Adjust tool | SET | | Lighting equipement | SET | | Oil splash-prevention cover | SET | | Coolant sys. | SET | | Bar end sensor | SET | | Manually loaded single bar feeder | SET |
|
|
| Optional Accessories: | | | | Item | UNIT | | Oil tank | SET | | Slotting attachment | SET | | Threading attachment | SET | | Automatic bar feeder | SET | | Cams compeleted | SET |
| * All specification are subject to change without notice in advance * |
|
|
